Back to Location Module
Disabling Magenta Linework and Dots (Bold Selection Mode)
Updated August 22, 2024
This article applies to:
- RoadEng Civil
- RoadEng Forestry
- Softree Optimal
The heavy magenta linework and dots are intended to highlight the active alignment to make it easier to keep track of which alignment is editable.
Figure 1: Magenta Linework and Dots
Note: It will not plot when printed in a multiplot output.
To turn this feature off: Setup | Location Setup | General, uncheck the Bold Selection Mode option
Figure 2: Bold Selection Mode
The Profile, Plan and Section views should look like the figure below.
Figure 3: Bold Mode Disabled