Back to Location Module
Wall 4 - Retaining Wall
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Retaining Wall
Retaining Wall: Back fill to top of cut. The offset from the base of the wall is calculated by: Offset = WallHeight * WallFactor
Typical Cross Section
Parameters
WallThick | Width of a wall (as seen in the cross section). | |
WallHeight | Height of a wall. | |
WallFactor | Controls the horizontal offset from the wall to backslope. e.g. offset = WallFactor * WallHeight | |
WallBackSlope | Slope of the base of the backfill material. | |
bBackFillToTopo | Set to 1 if the back fill slope should adjust to close at topo. | |
WallBackfillSlope | Slope of top of backfill. This slope is ignored if bBackFillToTopo is 1. | |
WallBFillOffset | Offset of backfil from base of the wall. |