Back to Location Module
Slope Components 8
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
3 Legs
This component creates a slope with 3 legs... Top, middle and optional closing.
Typical Cross Section
Parameters
| bApplyInCut | If set to 1 the component will be applied if the attachment point is below topo. | |
| bApplyInFill | If set to 1 the component will be applied if the attachment point is above topo. | |
| bClose | Set to 1 if a closing slope should be included. | |
| TopDX | Offset distance (HD) from connection point to top / inside of the slope. | |
| TopSlp | Slope from connection point to top of the slope. | |
| MidDY | Vertical height of the middle section. | |
| MidSlp | Slope of middle section. | |
| FinalCutSlp | Closing slope in cut. | |
| FinalFillSlp | Final closing slope in fill. |