Back to Location Module
Slope Components 7
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Bench at Subsurface Component
This component creates a bench at Layer. It doesn't apply in fill.
Typical Cross Section
Parameters
| Subsurface | Subsurface | |
| SlopeBelowSubsurf | Slope below subsurface layer. | |
| BenchWidth | Width of the bench. | |
| BenchSlope | Slope of the bench (positive downwards). | |
| FinalCutSlp | Final slope closing with topo | |
| bCloseToTopo | If set to 1, a final slope will always be created to close to ground. |