Back to Location Module
Slope Components 6
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Benches
This component creates up to 5 benches. The component can be applied in cut or fill or both. A closing slope can be included.
Typical Cross Section
Parameters
| bApplyInCut | Set to 1 to apply this component when the connection point is in cut. | |
| bApplyInFill | Apply component when the connection point is below stripped topo. | |
| bCloseToTopo | If set to 1, a final slope will always be created to close to ground. | |
| FinalCutSlp | Closing slope in cut. | |
| FinalFillSlp | Final closing slope in fill. | |
| BenchSlope | Bench slope. | |
| BenchHeight | Height of the bench. | |
| BenchBaseWidth | Width of bench. | |
| BenchBaseSlope | Slope of the base (bottom) of the bench. |