Back to Location Module
Slope Components 5
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Cut Slope by Depth Component
This component varies the slope based on depth of cut. Two depths are entered defining 3 possible slopes.
Typical Cross Section
Parameters
| bApplyInFill | If set to 1 the a cut slope (FinalFillSlp) will be applied when the connection point is above topo. | |
| FinalFillSlp | Final fill slope. Only used if bApplyInFill is set. | |
| CutDepth1 | Smallest cut depth. | |
| CutDepth2 | Second cut depth. Should be greater or equal to CutDepth1. | |
| CutSlope1 | Slope for cuts less than CutDepth1. | |
| CutSlope2 | Slope for cuts greater than CutDepth1 and less than CutDepth2. | |
| CutSlope3 | Slope for cuts greater than CutDepth3 |