Back to Location Module
Roadway Components - RURAL 5
Updated May 06, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Three layer roadway component with paved shoulder and sod section.
Typical Cross Section
Default Material Assignment
| AcpThick | Thickness of pavement surface. |
| AcpWidth | Surfacing or lane width, for pavement layer. |
| BaseThick | Thickness of layer. |
| BaseFillSlope | Fill slope for base layer. |
| BaseHoffset | Horizontal offset from outside of the base to outside of the pavement layers. |
| SubbaseThick | Thickness of subbase layer. |
| SubbaseFillSlope | Fill slope % of subbase layer. |
| SubbaseHoffset | Horizontal offset from outside of subbase layer to outside of base layer. |
| ShoulderPaveWidth | Shoulder width |
| ShoulderPaveSlope | Slope of shoulder. Crown or super is added to this slope. |
| ShoulderPaveThick | Thickness of material under the shoulder. NOTE the shoulder base must tie into the sub-base layer. |
| ShoulderGravWidth | Additional shoulder width. |
| ShoulderGravSlope | Slope of outside shoulder. Crown or super is added to this slope. |
| _SUPER | Superelevation or crown |