Knowledge Base

Back to Location Module


Roadway Components - RURAL

Updated May 06, 2016


This article applies to:
  • RoadEng Civil
  • RoadEng Forestry

Rural I :

Up to three layer template with pavement inset optional paved and non-paved shoulder.

Typical Cross Section

Default Material Assignments

Parameters

AcpThick Thickness of pavement surface.
AcpWidth Surfacing or lane width, for pavement layer.
BaseThick Thickness of layer.
BaseFillSlope Fill slope for base layer.
SubbaseThick Thickness of subbase layer.
SubbaseFillSlope Fill slope % of subbase layer.
ShoulderPaveWidth Width of paved shoulder
ShoulderPaveThick Pavement thickness on shoulder.
ShoulderPaveSlp Slope of paved shoulder. Negative slopes down. Crown or super is added to this slope (if bSuperPavedShldr is set).
bShoulderPaveSuper Set to 1 to apply super to shoulder.
ShoulderGravWidth Width of gravel shoulder.
ShouldeGravSlope Slope of gravel shoulder. Negative slopes down. Crown or super is added to this slope (if bSuperGravelShldr is set).
bShoulderGravSuper Set to 1 to apply super to gravel shoulder.
_SUPER Superelevation or crown