Back to Location Module
Roadway Components - RAIL Track Surface
Updated February 15, 2024
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Up to four layer template with pavement inset and curb. Curb top and bottom rotate with super elevation.
Typical Cross Section
Default Material Assignments
Parameters
| AcpThick | Thickness of pavement surface. | |
| AcpThick2 | Thickness of top (second) layer of pavement (may be zero). | |
| AcpWidth | Surfacing or lane width, for pavement layer. | |
| BaseThick | Thickness of base layer. | |
| BaseFillSlope | Fill slope for base layer. | |
| SubbaseThick | Thickness of subbase layer. | |
| SubbaseFillSlope | Fill slope % of subbase layer. | |
| ShoulderWidth | Shoulder width | |
| ShoulderSlope | Slope of shoulder. Crown or super is added to this slope if bShoulderSuper is set. | |
| bShoulderSuper | Set to 1 if super should be applyied to super. | |
| Shoulder_V_Offset | Vertical offset from curb or asphalt to shoulder. | |
| CurbOutsideHeight | Height of curb back. | |
| CurbInsideHeight | Height of inside of curb. | |
| CurbBottomWidth | Curb and gutter bottom width. | |
| CurbBottomSlope | Slope of the bottom of the curb. | |
| CurbGutterWidth | Curb gutter width. | |
| CurbGutterSlope | Gutter Slope (super elevation or crown is added to this value) | |
| CurbTopWidth | Width of the top of the curb. | |
| bCurbApplySuper | Set to one if curb should be superelevated. | |
| _SUPER | Superelevation or crown |