Knowledge Base

Back to Location Module


Pad 2 - Road and Crane Pad

Updated May 09, 2016


This article applies to:
  • RoadEng Civil
  • RoadEng Forestry

Road and Crane Pad : Road with adjoining crane pad. Typical wind farm application.

Typical Cross Section

Parameters

RoadWidthTop surfacing layer width.
RoadTopSurfThickThickness of the top layer.
RoadBotSurfThickThickness of 2nd layer.
RoadBotSurfSlopeSlope of layer2 material.
RoadShoulderSlopeSlope of sholder. Crown or super is added to this slope.
RoadShoulderWidthWidth of shoulder.
RoadTopSrfSlpSlope of top layer.
PadTopSrfThick
PadDefDepthDefault vertcial offset from centerline. Positive is below CL and negative above.
PadElev
PadSlpSlope from edge of road to bottom of pad.
PadWidthPad width
PadShoulderWidthShoulder width
PadBotSrfThickThickness of the pad bottom surfacing material.
PadBotSlopeSlope (cross fall) of the pad measured perpindicular to the road.