Back to Location Module
Armor 3 - Apron Surface
Updated May 09, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
This component creates an armor surface on the merged surface.
Typical Cross Section
Parameters
| ArmorTopDX | Attachment point (shoulder) offset horizontal distance. | |
| ArmorTopSlp | Shoulder slope. | |
| ArmorMidSlp | Outside slope. | |
| ArmorBaseHeight | Height of apron base. | |
| ArmorBaseWidth | Width of the apron base. | |
| ArmorClosingSlp | Final fill. Outside closing slope from the top of the apron. | |
| bIncludeArmor | Set to 1 to include this component. Used to turn off the component by overrides. |