Back to Location Module
Ditches and Subcuts - SUBCUT 1
Updated May 06, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Cut into merged surface. The cut depth is measured from the attachment point. Usually placed before other components.
Typical Cross Section
Parameters
| SubCutDepth | Subcut depth | |
| SubCutWidthL | Subcut maximum width left. | |
| SubCutWidthR | Subcut maximum width right. | |
| SubCutBotSlope | Slope of the bottom of the subcut. | |
| SubCutSlopeIn | Inside slope. Usually vertical for if left and right widths are > 0. | |
| SubCutSlopeOut | Outside slope. | |
| bApplySuper | Set to 1 to superelevate the subcut. |