Back to Location Module
Ditches and Subcuts - DITCH 7
Updated May 06, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Inside ROW
Maintains user defined slopes inside the ROW. If the ditch is too deep, another slope is used to grade beyond the ROW.
Typical Cross Section
Parameters
| ROWOffset | Horizontal offset from CL to ROW. | |
| ROWSetback | Horizontal offset from ROW to outside of the ditch slope. | |
| DitchDefDepth | Default ditch depth to inside bottom of the ditch measured from centerline. | |
| DitchElev | Ditch elevation. This parameter should be overriden .i.e. explicitly set in menu Edit | Assign Parameters by Range. If this parameter is set to -99999 then the ditch depth is determined from DitchMaxDepth. | |
| DitchOutsideHeight | ||
| DitchInSlp | Ditch slope from attachment point (edge of road) to bottom of ditch. | |
| DitchBotSlp | Bottom of the ditch slope. | |
| SlopeBeyondROW | Slope beyond right of way limit. | |
| DitchDepth | Depth of the ditch measured from attachment point. |