Knowledge Base

Back to Location Module


Ditches and Subcuts - DITCH 3

Updated May 06, 2016


This article applies to:
  • RoadEng Civil
  • RoadEng Forestry

Vertical Tie

This component will vertically tie the bottom inside of the ditch to a feature. The inside slope (DitchInSlope) is maintained.

Typical Cross Section

Parameters

DitchInSlpDitch inside slope.
DitchDepthDepth of the ditch measured from attachment point.
DitchBotWdWidth of the bottom of the ditch (horizontal distance).
DitchBotSlpBottom of the ditch slope.
DitchDefDepthDefault ditch depth to inside bottom of the ditch measured from centerline.
bExcludeDitchSet to 1 to exclude the ditch. This parameter can be overriden.
Top