Back to Location Module
Ditches and Subcuts - DITCH 2
Updated May 06, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Ditch by Elevation
Assign ditch elevations along the alignment by overriding variable DitchElev. Enable/Disable by overriding bExcludeDitch.
Typical Cross Section
Parameters
| DitchDefDepth | Default ditch depth to inside bottom of the ditch measured from centerline. | |
| DitchElev | Ditch elevation. This parameter should be overriden .i.e. explicitly set in menu Edit | Assign Parameters by Range. If this parameter is set to -99999 then the ditch depth is determined from DitchMaxDepth. | |
| DitchInSlp | Ditch slope from attachment point (edge of road) to bottom of ditch. | |
| DitchBotWd | Width of the bottom of the ditch (horizontal distance). | |
| DitchBotSlp | Bottom of the ditch slope. | |
| bExcludeDitch | Set to 1 to exclude the ditch. This parameter can be overriden. | |
| DitchDepth | Depth of the ditch measured from attachment point. |