Back to Location Module
Ditches and Subcuts - SUBCUT 2
Updated May 06, 2016
This article applies to:
- RoadEng Civil
- RoadEng Forestry
Subcut below sub-grade. Place in template after all other components.
Typical Cross Section
Parameters
| SubCutDepth | Subcut depth measured from the component attachment point. | |
| SubCutWidthL | Sub cut maximum width left. | |
| SubCutWidthR | Subcut maximum width R. | |
| SubCutBotSlope | Slope of the bootom of the sub cut. Super is added to this if bApplySuper is on. | |
| SubCutSlopeOut | Outside slope. | |
| SubCutSlopeIn | Inside slope. This is usually vertical if subcut is 2 sided. | |
| bApplySuper | Set to 1 to superelevate the bottom of the sub-cut. |